Hi,
I have two bladeRFs connected and am trying to make one the master and the other the slave for a trigger before streaming a binary file. I am using the CLI over VS code to communicate with the blades. So right now, when I access one blade and set it as the master, I then go to access the other one to arm it as the slave before going back to access the master and fire the trigger. Problem is, when I leave the armed master board to communicate with the other board, the master board is getting disarmed. I assume I'm not doing this the right way and am wondering how I am supposed to proceed to get this to work?
Thanks!
Trigger Difficulties with Two Blades (xA4) connected.
-
careyda
- Posts: 2
- Joined: Fri Jul 05, 2024 9:31 am
-
abigaazer
- Posts: 1
- Joined: Wed Jul 17, 2024 9:58 pm
Re: Trigger Difficulties with Two Blades (xA4) connected.
The fnaf franchise has also expanded into books, merchandise, and even a movie adaptation.