Unknown FPGA size. Skipping FPGA configuration...

[qnzy]

I just got my bladeRF 2.0 micro xA5. I've installed bladeRF from the Ubuntu repository.
When I'm trying to launch sdr++ or gqrx, I get the following error messages:


[bladeRF common] init: DEBUG: entering initialization
[bladeRF source] init: Opening Nuand bladeRF with device identifier string '*:instance=0'
[WARNING @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:418] Unknown FPGA size. Skipping FPGA configuration...
[WARNING @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:419] Skipping further initialization...


I did not find much when googling for this error. Do I need to install new versions of the software on the computer. Or do
I need to update the firmware on the bladeRF?

Any help is appreciated.

[robert.ghilduta]

Please update libbladeRF to 2021.10 or later to ensure bladeRF 2.0 micro xA5 support is built into the library.