Sample capture to file
-
- Posts: 1
- Joined: Fri Oct 21, 2016 8:37 pm
Sample capture to file
I'd like to capture a few hundred milliseconds of I/Q samples to a file from the linux command line. What is the easiest way to do this?
-
- Posts: 11
- Joined: Mon Apr 11, 2016 12:41 pm
Re: Sample capture to file
You can do that with bladeRF-cli very easily. See here:
https://github.com/Nuand/bladeRF/wiki/G ... ng_Samples
Basically, configure your RX parameters (sample rate, frequency, gain, etc), set the output file and the number of samples you'd like to receive, then receive samples with "rx start".
https://github.com/Nuand/bladeRF/wiki/G ... ng_Samples
Basically, configure your RX parameters (sample rate, frequency, gain, etc), set the output file and the number of samples you'd like to receive, then receive samples with "rx start".