Page 1 of 1
GPIO Standoff measurements
Posted: Sun Apr 20, 2014 4:21 pm
by gaprice2354
Hi
Does anyone know the proper standoffs to mount the GPIO board to the bladerf main board?
Thanks
Re: GPIO Standoff measurements
Posted: Sun Apr 27, 2014 4:44 am
by robert.ghilduta
The average mounting height should be 0.197" according to BTH-030-01-F-D-A's datasheet
http://www.samtec.com/ftppub/pdf/BTH.PDF .
Using a micrometer, I just measured a height of 0.200".
Re: GPIO Standoff measurements
Posted: Sun Apr 27, 2014 7:19 am
by piranha32
Looks like 5mm standoffs should be fine.