Official bladeRF forum

Hi,

I am trying to get SDR and bladerf working together. The SDR sensed the connect bladeRF, but i am getting no signal on the SDR console. Any new is appreciated. Attached here is the screen shots of the SDR console images. Also, if anyone could suggest a getting started document for SDR it would be of great help.


Thanks
Santosh

Are you getting any messages while loading FPGA ?

Hi Olaf,

I am getting the following message while loading fpga. The load was successful and I got the led's flashing.
Thanks
Santosh

Have you clicked the 'start' button?

It may sound simple, but something similar happens to me after I connect the bladeRF, load the FPGA, and open SDR radio the signal doesn't show up until I click that button (some time before, it used to prompt me for a radio).

Yes, I have clicked the start button. Sorry about the earlier screen shot. Attached here is the screen shot with start button. Still no signal.

Try at command prompt:
bladerf-cli peek lms 0 20

Attached here is the output of the command

Attached here is the output of the command with the SDR console. Once the SDR console is started I started getting the error Failed to access peripheral.