Official bladeRF forum

I download the so-called newest firmware from the blog. It says that "you can now store FPGA images on the SPI flash by running `bladeRF-cli -L hostedx40.rbf`. This will allow your bladeRF to read an FPGA image from flash and program the FPGA without the need of a host computer. "
But after I flash the latest firmware and unplug my bladeRF and conected it again,the FPGA is still unloaded, how can I realize the headless mode??

thank you all!

According to bladeRF-cli.exe --help, the -L switch prints the libbladeRF version and exits. Mine does this exact behavior. It must be a different software version or commandline switch.

syntroniks wrote:According to bladeRF-cli.exe --help, the -L switch prints the libbladeRF version and exits. Mine does this exact behavior. It must be a different software version or commandline switch.

thank you for answering my question,I found that only the linux has the latest comand line version.