Page 1 of 1
Can this board be extended to 2*2 MIMO?
Posted: Wed Aug 28, 2013 1:37 am
by asd2014
Dear Sir,
I am interested in bladeRF. I read in your forum that the external clock does not work at a time. So how can we extend to 2*2 MIMO without this clock?
Best regards,
asd
Re: Can this board be extended to 2*2 MIMO?
Posted: Wed Aug 28, 2013 5:23 am
by bpadalino
That clock is required to get 2*2 MIMO working. We've tested that boards can be synchronized to accept and provide clocks using the SMB port, but we haven't put the code into libbladeRF yet. It's on our
task list. Sorry for the inconvenience.
Re: Can this board be extended to 2*2 MIMO?
Posted: Wed Aug 28, 2013 5:30 am
by asd2014
Thanks a lot for your quick reply. Could you please tell me When do you expect to include it into libbladeRF?
Re: Can this board be extended to 2*2 MIMO?
Posted: Wed Aug 28, 2013 5:33 am
by bpadalino
The code to select the clock source and turn on the output isn't very difficult, so hopefully it's something we knock off very quickly this weekend.
The HDL and host code required to understand the relative offsets of each of the boards and get samples to go out in a timed fashion is a bit more complicated, so that might take a while.
If you are willing to just have samples which are received using a common baseband clock, that should be done soon. True synchronization for MIMO operation is a while off. Sorry for the inconvenience.