Official bladeRF forum

I'm a beginner of using bladeRF SDR.

I accidentally wrote the FPGA image for xA40 to the FPGA of my bladeRFx40.
USB is working well and find the bladeRF x40, but bladerf-cli can't connect to it.
OS is windows 11.

I think the wrong FPGA image cause the fail of connection.

Could you please provide how to rewrite it or solve this problem?

I have tried the recover FPGA image and firmware with the page of "Upgrading using the FX3 bootloader (Recovery Method)".
Then I have successfully re-written the FPGA image with the firmware v1.9.0. Because I could not use open command with the latest firmware of v2.6.0.
Thank you.