Official bladeRF forum

I am following this link of bladeRF to set the sampling rate up to 100 MHz - https://www.nuand.com/2023-02-release-1 ... bandwidth/
I am receiving signals with osmocom source, so in the device parameter I am writing "bladerf=0,sample_format=8,feature=oversample", as is explained in the link. But, this is not working because it appears the error RuntimeError: set_sample_rate: Failed to set sample rate: Provided parameter was out of the allowable range (-2).
I don't know if someone knows what it is happening because I am following the steps of the official page of bladerf.
Thanks!

I also read the instructions and followed the steps there but the geometry dash error still occurs and it doesn't work

There is a problem with the parameter provided for the sample rate, possibly because it is out of range, and I recommend verifying the syntax and ensuring the firmware and drivers are up to date to resolve the problem. slope

Usually there will be few program errorsbasketbros. However, perhaps the problem you shared appears quite rarely. You can contact customer service.

There are typically only a few errors in the basketbros program. However, the issue you mentioned seems to be quite uncommon. I think you need to connect with customer service for assistance paper minecraft