Official bladeRF forum

Hi, I am currently working on a project to send and receive OFDM frames between two Bladerf's boards, however, i am unable to configure the receiving board to run for a long period. Instead, it runs for a few seconds and it stops. I am only using the terminal by the way. So any help about how to configure the receiving board to keep running (basically help about how to control the receiver about running time)

update: i managed to somewhat get past through this.

Now I am struggling with micro A4 board, it's only operating at 2.4GHz. Please help.
Like on the terminal, it shows that setting TX1 frequency to 300M, but when i view my signal on the spectrum analyzer it's on 2.4GHz, and if i plug the x40 and run the same script, my signal shows on my set frequency.