set frequency tx1 1575.42M
set samplerate tx1 2.6M
set bandwidth tx1 2.5M
set gain tx1 66
set gain tx1 dsa 0
tx config file=gpssim.bin format=bin
tx start
tx wait
It seems only to transmit for far less than one minute (observed with xgps). not enough to get a fix.
I also noted that these commands were deprecated for my bladeRF: (for DC offset)
But I don't know if it is relevant to the problem since I think with this version the DC offset is automatic.
Note that gpssim.bin is a 8 bit I/Q data file generated from gps-sdr-sim supposed to last for 3 minutes.
Also, I can spoof with success in my lab with my hackrf.
You can try adjusting parameters like frequency, sampling rate, bandwidth,Geometry Dash Online and gain to see if signal transmission is maintained longer.
set frequency tx1 1575.42M
set samplerate tx1 2.6M
set bandwidth tx1 2.5M
set gain tx1 66
set gain tx1 dsa 0
tx config file=gpssim.bin format=bin
tx start
tx wait
It seems only to transmit for far less than one minute (observed with xgps). not enough to get a fix.
I also noted that these commands were deprecated for my bladeRF: (for DC offset)
But I don't know if it is relevant to the problem since I think with this version the DC offset is automatic.
Note that gpssim.bin is a 8 bit I/slope game Q data file generated from gps-sdr-sim supposed to last for 3 minutes.
Also, I can spoof with success in my lab with my hackrf.
Thank you for the help!
Take my hand and start exploring the wonderful things ahead