How to receive signal from two channal of one bladeRF with the same gain
Posted: Fri Sep 29, 2023 6:59 am
Hello, everyone!
When I try to use one bladeRF to receive two channel signal, I found even I set the same gain for the two channel by "set gain rx1 10" and "set gain rx2 10", the receiving gain is still not the same. The gain on RX2 is always much lower than RX1.
My code is
set frequency rx1 433M
set frequency rx2 433M
set samplerate 1MHz
set bandwidth 500kHz
set agc off
set gain rx1 10
set gain rx2 10
rx config file=testsc16q11 format=bin n=10M channel=1,2 timeout=60s
I don't know what the reason is. Has anyone encountered a similar situation?
Thank you very much for your help
When I try to use one bladeRF to receive two channel signal, I found even I set the same gain for the two channel by "set gain rx1 10" and "set gain rx2 10", the receiving gain is still not the same. The gain on RX2 is always much lower than RX1.
My code is
set frequency rx1 433M
set frequency rx2 433M
set samplerate 1MHz
set bandwidth 500kHz
set agc off
set gain rx1 10
set gain rx2 10
rx config file=testsc16q11 format=bin n=10M channel=1,2 timeout=60s
I don't know what the reason is. Has anyone encountered a similar situation?
Thank you very much for your help