[ERROR @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:438] bladerf2_open: invalid FPGA size: 115
Posted: Thu Mar 24, 2022 3:12 am
Hello
We have purchased a bladeRF kit (bladeRF 2.0 micro xA5) from Nuand and
then we got a problem while installing it on our ubuntu 20.04 system,
the error that we have is as follows , knowing that the actual size is
77 KLE
[ERROR @
host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:438]
bladerf2_open: invalid FPGA size: 115
Error: An unexpected error occurred
So we tried to use the recovery command to re-burn the latest firmware
(bladeRF_fw_v2.4.0.img) following the instructions stated in the
following link, but when we reach the 8th step which is "open" we got
the above error.
https://github.com/Nuand/bladeRF/wiki/U ... ry_command
Note: first we were using older (not the latest) versions of the
libbladeRf libraries and tried to install the kit so we got warnings
about using older versions of that library, but when we updated all the
libraries we got the mentioned error.
So please, we are asking for help to solve this problem
We have purchased a bladeRF kit (bladeRF 2.0 micro xA5) from Nuand and
then we got a problem while installing it on our ubuntu 20.04 system,
the error that we have is as follows , knowing that the actual size is
77 KLE
[ERROR @
host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:438]
bladerf2_open: invalid FPGA size: 115
Error: An unexpected error occurred
So we tried to use the recovery command to re-burn the latest firmware
(bladeRF_fw_v2.4.0.img) following the instructions stated in the
following link, but when we reach the 8th step which is "open" we got
the above error.
https://github.com/Nuand/bladeRF/wiki/U ... ry_command
Note: first we were using older (not the latest) versions of the
libbladeRf libraries and tried to install the kit so we got warnings
about using older versions of that library, but when we updated all the
libraries we got the mentioned error.
So please, we are asking for help to solve this problem