Unknown FPGA size. Skipping FPGA configuration...
Posted: Fri Feb 04, 2022 4:26 pm
I just got my bladeRF 2.0 micro xA5. I've installed bladeRF from the Ubuntu repository.
When I'm trying to launch sdr++ or gqrx, I get the following error messages:
[bladeRF common] init: DEBUG: entering initialization
[bladeRF source] init: Opening Nuand bladeRF with device identifier string '*:instance=0'
[WARNING @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:418] Unknown FPGA size. Skipping FPGA configuration...
[WARNING @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:419] Skipping further initialization...
I did not find much when googling for this error. Do I need to install new versions of the software on the computer. Or do
I need to update the firmware on the bladeRF?
Any help is appreciated.
When I'm trying to launch sdr++ or gqrx, I get the following error messages:
[bladeRF common] init: DEBUG: entering initialization
[bladeRF source] init: Opening Nuand bladeRF with device identifier string '*:instance=0'
[WARNING @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:418] Unknown FPGA size. Skipping FPGA configuration...
[WARNING @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:419] Skipping further initialization...
I did not find much when googling for this error. Do I need to install new versions of the software on the computer. Or do
I need to update the firmware on the bladeRF?
Any help is appreciated.