Official bladeRF forum

Hi,
I tried pluging the bladeRF into a 2.0 USB and changing the loopback option as instructed, and I still get the same results as in my previous post.
Best

There isn't anything software-wise that could be wrong here, as far as I can think of. At this point, I suspect that something on the device is failing, and I think the best course of action would be to email [email protected] to report this and request and RMA. When you do so, please include a summary of the problem and what we tried here, that I (Jon) was assisting you on the forums, and a link to this thread.

- Jon

OK. thanks!