Has anybody designed a case for XB-200 mounted on BladeRF in order to get it printed?
regards
BladeRF+XB-200 transverter case?
-
- Posts: 455
- Joined: Thu Jun 06, 2013 8:15 pm
Re: BladeRF+XB-200 transverter case?
Shockwave posted this nice 3D printed case design.
piranha32 has been working on a really nice metal enclosure (and I'm greatly looking forward to his blog post about it).
For a quick and dirty solution, I modified a regular case to fit my transverter by drilling some holes on the top and using longer screws.
I assume there should eventually be an "official" case similar to the existing one, considering that Rob had printed some very preliminary prototypes a while back. I'm not too sure on this though - you'd have to check with him.
piranha32 has been working on a really nice metal enclosure (and I'm greatly looking forward to his blog post about it).
For a quick and dirty solution, I modified a regular case to fit my transverter by drilling some holes on the top and using longer screws.
I assume there should eventually be an "official" case similar to the existing one, considering that Rob had printed some very preliminary prototypes a while back. I'm not too sure on this though - you'd have to check with him.
-
- Posts: 1
- Joined: Sun Feb 22, 2015 1:56 am
Re: BladeRF+XB-200 transverter case?
Case for Nuand bladeRF X40/X115 with the XB-200 LF/MF/HF/VHF transverter board
While there is no case available from Nuand for the XB-200 LF/MF/HF/VHF transverter board, I decided to build my own case. I tried to document it, because I saw that several owners of a LF/MF/HF/VHF transverter XB-200 board where looking for a case. Description (not easy to fit the 256 kBytes)
Drillplan
While there is no case available from Nuand for the XB-200 LF/MF/HF/VHF transverter board, I decided to build my own case. I tried to document it, because I saw that several owners of a LF/MF/HF/VHF transverter XB-200 board where looking for a case. Description (not easy to fit the 256 kBytes)
Drillplan