Hi,
I am trying to get SDR and bladerf working together. The SDR sensed the connect bladeRF, but i am getting no signal on the SDR console. Any new is appreciated. Attached here is the screen shots of the SDR console images. Also, if anyone could suggest a getting started document for SDR it would be of great help.
Thanks
Santosh
SDR and BladeRF
-
- Posts: 9
- Joined: Sat Mar 01, 2014 7:36 pm
Re: SDR and BladeRF
Are you getting any messages while loading FPGA ?
-
- Posts: 10
- Joined: Sun Mar 23, 2014 12:07 pm
Re: SDR and BladeRF
Hi Olaf,
I am getting the following message while loading fpga. The load was successful and I got the led's flashing.
Thanks
Santosh
I am getting the following message while loading fpga. The load was successful and I got the led's flashing.
Thanks
Santosh
-
- Posts: 7
- Joined: Mon Feb 24, 2014 2:13 pm
Re: SDR and BladeRF
Have you clicked the 'start' button?
It may sound simple, but something similar happens to me after I connect the bladeRF, load the FPGA, and open SDR radio the signal doesn't show up until I click that button (some time before, it used to prompt me for a radio).
It may sound simple, but something similar happens to me after I connect the bladeRF, load the FPGA, and open SDR radio the signal doesn't show up until I click that button (some time before, it used to prompt me for a radio).
-
- Posts: 10
- Joined: Sun Mar 23, 2014 12:07 pm
Re: SDR and BladeRF
Yes, I have clicked the start button. Sorry about the earlier screen shot. Attached here is the screen shot with start button. Still no signal.
-
- Posts: 9
- Joined: Sat Mar 01, 2014 7:36 pm
Re: SDR and BladeRF
Try at command prompt:
bladerf-cli peek lms 0 20
bladerf-cli peek lms 0 20
-
- Posts: 10
- Joined: Sun Mar 23, 2014 12:07 pm
Re: SDR and BladeRF
Attached here is the output of the command
-
- Posts: 10
- Joined: Sun Mar 23, 2014 12:07 pm
Re: SDR and BladeRF
Attached here is the output of the command with the SDR console. Once the SDR console is started I started getting the error Failed to access peripheral.