using signaltap
-
- Posts: 5
- Joined: Sat Oct 08, 2022 6:53 pm
using signaltap
Why can't bladeRF-cli go into interactive mode after i load .sof files with signaltap, because I want to use bladeRF-cli -i to send data and grab it through signaltap in FPGA.
-
- Posts: 156
- Joined: Thu Feb 28, 2013 11:14 pm
Re: using signaltap
There is a lot of initialization that happens when bladeRF-cli launches. You should first load the sof, then launch bladeRF-cli.
If that doesn't work, you may want to launch bladeRF-cli, load an FPGA, then flash your SOF, then close out of bladeRF-cli, and relaunch bladeRF-cli.
If that doesn't work, you may want to launch bladeRF-cli, load an FPGA, then flash your SOF, then close out of bladeRF-cli, and relaunch bladeRF-cli.