I am trying to use the BladeRF xA9 with the OAI software. I am unable to set the board's parameters, I enter the bladeRF-cli, I set my parameters but if I leave it they go back to the stock ones. The same happens if I try using
Code: Select all
bladeRF-cli -e "set frequency tx 2680000000"
Code: Select all
bladeRF-cli -e print
Code: Select all
TX1 Frequency: 2400000000 Hz (Range: [47000000, 6000000000])
Also, if I try to run the lte-softmodem by OAI, I get
Code: Select all
[BRF] error calibrating
[BRF] brf_error: Operation not supported
I am running Ubuntu and the information on the board are
ThanksbladeRF-cli version: 1.9.0-git-2b90ed39-dirty
libbladeRF version: 2.5.0-git-2b90ed39-dirty
Firmware version: 2.4.0-git-a3d5c55f
FPGA version: 0.15.0 (configured from SPI flash)