Hello!
I want to monitor mobile network signals with BladeRF. Generally it works, but sensitivity is very poor. I've added MAX2615 LNA - it works better, but still far from the sensitivity of regular mobile phone.
What can I do to improve sensitivity ?
How to increase sensitivity
-
- Posts: 1
- Joined: Tue Dec 22, 2020 4:39 pm
Re: How to increase sensitivity
Hi Jarek,
Firstly, I would go for a narrow band LNA, with 30dB of gain with a NF of no more than 3dB.
The MAX2615 LNA @ 40MHz to 4GHzand is too wide, and therefore will increase your overall apparent noise floor.
Secondly, use a dedicated directional antenna, with high gain, that is suited to your required band.
You will then close to what is achievable.
I use a 500mm dish with an LNA, a 2 element Moxon for 945MHz for BAND IIIV-3G, Australia.
Cheers
Firstly, I would go for a narrow band LNA, with 30dB of gain with a NF of no more than 3dB.
The MAX2615 LNA @ 40MHz to 4GHzand is too wide, and therefore will increase your overall apparent noise floor.
Secondly, use a dedicated directional antenna, with high gain, that is suited to your required band.
You will then close to what is achievable.
I use a 500mm dish with an LNA, a 2 element Moxon for 945MHz for BAND IIIV-3G, Australia.
Cheers