FATAL: [bladeRF source] Failed to open bladeRF device *:instance=0

Discussions related to schematic capture, PCB layout, signal integrity, and RF development
Post Reply
boyerkg
Posts: 3
Joined: Mon Jan 28, 2019 4:33 pm

FATAL: [bladeRF source] Failed to open bladeRF device *:instance=0

Post by boyerkg »

After realizing that osmocom source was not finding the bladerf=0 instance, I trapped the real error:

FATAL: [bladeRF source] Failed to open bladeRF device *:instance=0

Does anyone know why osmocom source cannot find the sdr bladerf?

bladeRF-cli runs fine. It sees the bladerf sdr, and I can read the configuration.

I get the same error when I run osmocom_fft. I built gnuradio on another machine with the latest version of gnuradio (3.7.13.4), and it has the same problem.

Regards,

Keith
OskarM
Posts: 19
Joined: Sun Dec 09, 2018 3:02 pm

Re: FATAL: [bladeRF source] Failed to open bladeRF device *:instance=0

Post by OskarM »

HI,
did you use pyBOMBS to instal gnuradio? try to rebuild gr-osmosdr (only)
b.r.
Post Reply