BladeRF 2.0 micro xA4 DC OFFSET issue

Having issues with the site, hardware, source code, or any other issues?
Post Reply
dakota56
Posts: 2
Joined: Sat Apr 04, 2020 2:37 am

BladeRF 2.0 micro xA4 DC OFFSET issue

Post by dakota56 »

Hello ,

Using Gnuradio I made a simple AM transmitter with OSmocom sink module. (carrier frequency = 110.1M, baseband freq=90Hz)
The problem is that I can clearly see a big spike at 110.1M and a small -F frequency as it is typical for a DC offset issue.

I also tried with osmocom_siggen and I got the same problem. Also when I try with osmocom_siggen to modify the DC offset parameters I got the following message in the terminal "set_dc_offset: could not set dc offset : Operation not supported"

Is there any way to correct this DC offset ? The BladeRF 2.0 micro specs indicate that DC offset correction is automatic but I can clearly see that it's not here.
Please help !

Dimitri
Post Reply