BladeRF 2.0 micro AX9 - configuration not applying

[miguel3145]

Hi everyone !

This is my first post on this forum so I might be missing some rules and good habits.
My problem is the following, I installed the bladeRF drivers/libraries, libusb > 1.0.16 and my bladeRF is recognized by the bladeRF-cli.
I want to edit the configurations for tx, rx, bandwidth frequencies aswell as the sample rate. The "set" command for all of these does not return any errors (check pictures attached) and when I print the configuration is shows that the settings have changed. But if I quit bladeRF-cli and come back all of my modifications have disappeared. It goes the same way for changing the tuning_mode.

Am I missing something regarding the way to write the configuration on the bladeRF ?

bladeRF-cli version: 1.9.0-git-fe3304d
libbladeRF version: 2.5.1-git-fe3304d

Firmware version: 2.4.0-git-a3d5c55f
FPGA version: 0.15.3 (configured from SPI flash

Thanking everyone in advance for your inputs !
Sincerely.



https://drive.google.com/file/d/1y8-rQ2 ... drive_link
https://drive.google.com/file/d/1PVS7Z2 ... drive_link
https://drive.google.com/file/d/18eVJ7t ... drive_link
https://drive.google.com/file/d/1C_RGTL ... drive_link
https://drive.google.com/file/d/1yhzTxL ... drive_link
https://drive.google.com/file/d/1WotVId ... drive_link