How to validate that BladeRF is transmitting
Posted: Tue Jan 22, 2019 12:49 pm
Hello,
I am attempting to run srsLTE UE on the bladeRFx115 board I have.
I am attempting to attach the UE to an LTE picocell
All of the debug messages on both sides imply that the bladeRF is properly decoding the eNB control channel, it receives the SIBs and then it trys to transmit a RACH request.
The Picocell never sees the transmit from the BladeRF.
I am powering the BladeRF with USB3.0 power. Is that acceptable? Or do I need a separate power supply?
Is there a way to easily verify that the board can transmit properly?
Thanks,
Dave
I am attempting to run srsLTE UE on the bladeRFx115 board I have.
I am attempting to attach the UE to an LTE picocell
All of the debug messages on both sides imply that the bladeRF is properly decoding the eNB control channel, it receives the SIBs and then it trys to transmit a RACH request.
The Picocell never sees the transmit from the BladeRF.
I am powering the BladeRF with USB3.0 power. Is that acceptable? Or do I need a separate power supply?
Is there a way to easily verify that the board can transmit properly?
Thanks,
Dave