Transverter dimensions
Posted: Thu Mar 13, 2014 4:09 pm
Can you tell me the approx dimensions of the transverter mounted on the bladerf? Just planning out case size
Approximate dimensions including all SMA extremities are:
- 4.75" from left to right (parallel with the bottom side header connector)
- 4.25" from top to bottom
- 0.8" deep (by itself - not mated with the bladeRF)
The tough part might be the external SMA's used for custom RX and TX filters. They mate upwards coming out of the top of the board.
They can be seen in the picture as J8-J9 and J10-J11.
Sorry for the late response.
