Hi,
built all the stuff succesfully, then tried to flash firmware. BladeRF-cli made an attempt to write the firmware, but exitted with an IO error
about reading 0x00 when it expected 0x43.
After that, I was unable to see the device any more on USB:
bladeRF-cli -b -f latest.img
Failed to open device (NULL): No devices available
Could not open device
lsusb:
Bus 001 Device 010: ID 04b4:00f3 Cypress Semiconductor Corp.
So what has happened here? Have bricked my device already????
Bladerf not seen by bladeRF-cli after failed firmware flash
-
- Posts: 30
- Joined: Fri Mar 01, 2013 4:37 am
-
- Posts: 303
- Joined: Mon Mar 04, 2013 4:53 pm
Re: Bladerf not seen by bladeRF-cli after failed firmware fl
You haven't bricked your device, but it's lost its mind a little bit. Please see this forum post for instructions on how to recover your bladeRF so it thinks it's a bladeRF and not a Cypress device.
-
- Posts: 30
- Joined: Fri Mar 01, 2013 4:37 am
Re: Bladerf not seen by bladeRF-cli after failed firmware fl
Phew, thanks, was getting worried that I'd have to dig out the jtag interface there....
thanks!!
thanks!!
-
- Posts: 303
- Joined: Mon Mar 04, 2013 4:53 pm
Re: Bladerf not seen by bladeRF-cli after failed firmware fl
No problem. Let us know how it goes in the end. I want to make sure you were able to recover.
-
- Posts: 30
- Joined: Fri Mar 01, 2013 4:37 am
Re: Bladerf not seen by bladeRF-cli after failed firmware fl
Yep, that worked. Two small notes: Cypress will apparently not send account registrations mails to gmail. I tried several times but had to use a non-gmail address. Also, a apt-get install libqt4-dev is required before cyusb_linux will build. But the USB is fixed now, and the firmware flashed correctly now. I see:
Backend: libusb
Serial:
USB Bus: 4
USB Address: 7
On to the next steps of getting this working..... Thanks!!
Backend: libusb
Serial:
USB Bus: 4
USB Address: 7
On to the next steps of getting this working..... Thanks!!