Blade 2.0 micro xA4 - GPS spoofing
Posted: Thu Nov 02, 2023 9:46 am
Hey guys,
I have this script for the bladeRF 2.0 xA4:
It seems only to transmit for far less than one minute (observed with xgps). not enough to get a fix.
I also noted that these commands were deprecated for my bladeRF: (for DC offset)
But I don't know if it is relevant to the problem since I think with this version the DC offset is automatic.
Note that gpssim.bin is a 8 bit I/Q data file generated from gps-sdr-sim supposed to last for 3 minutes.
Also, I can spoof with success in my lab with my hackrf.
Thank you for the help!
I have this script for the bladeRF 2.0 xA4:
Code: Select all
set frequency tx1 1575.42M
set samplerate tx1 2.6M
set bandwidth tx1 2.5M
set gain tx1 66
set gain tx1 dsa 0
tx config file=gpssim.bin format=bin
tx start
tx wait
I also noted that these commands were deprecated for my bladeRF: (for DC offset)
Code: Select all
cal lms
cal dc tx
Note that gpssim.bin is a 8 bit I/Q data file generated from gps-sdr-sim supposed to last for 3 minutes.
Also, I can spoof with success in my lab with my hackrf.
Thank you for the help!