Hello, after updating to the latest (10 PM EST 8/2/2012) bladeRF git and doing a full re-make, I connected my bladeRF to a USB port in my vmware ubuntu machine. dmesg reports:
[ 308.902184] parport0: ppdev0 forgot to release port
[ 374.803574] usbcore: deregistering interface driver nuand_bladerf
[ 394.028940] usbcore: registered new interface driver nuand_bladerf
[ 412.463458] usb 3-2.1: new high-speed USB device number 7 using xhci_hcd
[ 412.489722] usb 3-2.1: New USB device found, idVendor=1d50, idProduct=6066
[ 412.489759] usb 3-2.1: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 412.489909] usb 3-2.1: Product: bladeRF
[ 412.489952] usb 3-2.1: Manufacturer: Nuand
[ 412.497135] xhci_hcd 0000:03:00.0: xHCI xhci_add_endpoint called with enabled ep e6ee2780
[ 412.497182] xhci_hcd 0000:03:00.0: xHCI xhci_add_endpoint called with enabled ep e6ee27d8
[ 412.497196] xhci_hcd 0000:03:00.0: xHCI xhci_add_endpoint called with enabled ep f6af3180
[ 412.527356] nuand_bladerf 3-2.1:1.0: Nuand bladeRF device is now attached
Can someone please post the correct output when connecting to a SS port so I can compare? I see this is an xhci port but it still calls it a high-speed device. Thank you, I beleive this information is valuable to have available to the community as a debugging aid.
usb 6-2: new SuperSpeed USB device number 2 using xhci_hcd
usb 6-2: Parent hub missing LPM exit latency info. Power management will be impacted.
usb 6-2: New USB device found, idVendor=1d50, idProduct=6066
usb 6-2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
usb 6-2: Product: bladeRF
usb 6-2: Manufacturer: Nuand
Additionally, I find that it's convenient to look at the output of the 'usb-devices' command. This should show a "Spd" value of "5000" for the board.