About the fpga autoloading
Posted: Sun Jan 21, 2018 10:16 am
Hello, just noticed a few days ago that when i plug in the bladerf and launch the bladeRF-cli -i command, the fpga automatically gets loaded. I tried to disable the autoload doing as specified in the docs with bladeRF-cli -L -X, and it shows that is erasing blocks and finishes without errors, but whenever i disconnect the hackrf and connect again, i launch the bladeRF-cli in interactive mode and the fpga gets autoloaded. I noticed that under linux this doesn't happen, and i need to use the load fpga command to load it. The reason i want to disable the autoload is because it is recommeended in case of firmware upgrade, and because i want to upgrade it i need to disble it first. IS somehow the autoload tied to windows?. If it counts, when appeared the latest fpga i loaded it first on linux, but under virtual machine, as i was trying to experiment with yatebts, but lately i'm experimenting with gnuradio under windows in order to not having problems with usb transfer and using the usb3 natively under windows while i got another drive for a native linux install.
Thanks in advance!!
Thanks in advance!!