Hello Everyone ,
I am an undergrad who started working on BladeRF . I was trying to receive some samples as it is given in the tutorials on github ,
But whenever I type " rx start " and press Enter and check the State, It still shows as IDLE state
Attached is the sanpshot.
BladeRF not Receviing anything
-
- Posts: 303
- Joined: Mon Mar 04, 2013 4:53 pm
Re: BladeRF not Receviing anything
What's your samplerate? Is there a file called testsamples.csv in the directory you ran the CLI from?
-
- Posts: 455
- Joined: Thu Jun 06, 2013 8:15 pm
Re: BladeRF not Receviing anything
To further expand on bpadalino's questions -- note that your screenshot shows: # Samples: 1048576. When you consider your sample rate and that number of samples, I suspect you'll understand why the reception is finishing seemingly "immediately" and returning from the "Running" to "Idle" state.
For 5 seconds of samples, you could do something like:
For 5 seconds of samples, you could do something like:
Code: Select all
set samplerate rx 3M
set bandwidth rx 1.5M
rx config file=testsamples.csv format=csv n=15000000
rx start
rx